欢迎光临济南九恒机械制造有限公司网站

右上角联系方式

热门关键词:自行式升降机升降机厂家

新闻动态 News class

联系我们 contact us

济南九恒机械制造有限公司

联系人:李经理

手机:15966606398

电话:0531-81170766

QQ:1366870197

邮箱:1366870197@qq.com

地址:济南市济阳县创业路北首

机械新闻 News

当前位置: 首页 > 新闻动态 > 机械新闻
导轨式升降机的链条有啥用?
  • 作者:本站 来源:本站 日期:2017-01-01 19:33:29 人气:66

  • 导轨式升降机的链条有啥用?

         导轨式升降机链条可以根据货物的提升高度不同而调节链条的长度,同时对提高升降机的作业效率,扩大导轨式升降机的作业范围起着重要作用

    导轨式升降机链条可以根据货物的提升高度不同而调节链条的长度,同时对提高升降机的作业效率,扩大导轨式升降机的作业范围起着重要作用。The guide rail type elevator chain can adjust the length of the chain according to the lifting height of the goods, meanwhile, the operation efficiency of the elevator can be improved, and the operation range of the guide rail type elevator can be enlarged.

    1.导轨式升降机链条的松紧度应适宜,如果太紧将增加功率消耗,轴承易磨损,链条太松,易跳动和脱链。则最好的松紧程度为:链条的中部在提起或压下的时候,两链轮中心距的约为2%-3%。Rail type elevator chain tightness should be appropriate, if too tight will increase power consumption, bearing wear, the chain is too loose, and easy to jump off the chain. The best tightness is: in the middle of the chain lift or press down, the center distance of the two sprocket is about 2%-3%.

    2.旧的导轨式升降机链条上不能与部分新链条混合使用,否则容易在传动中产生冲击,拉断链条。Use and part of the new mixed chain guide rail type elevator chain of the old, otherwise easily in the transmission of shock, breaking the chain.

    3.导轨式升降机链条在工作中要记得及时加注润滑油。而润滑油则必须进入滚子和内套的整合间隙,以便改善工作条件,以减少磨损。Guide rail type lift chain in the work to remember the timely filling of lubricating oil. The lubricating oil must be integrated into the roller and the inner sleeve, so as to improve the working conditions and reduce the wear and tear.

    4.链轮装在轴上应没有歪斜和摆动。在同一传动组件中两个链轮的端面应位于同一平面内,链轮中心距在0.5米以下时,允许偏差1毫米链轮中心距在0.5米以上的时,允许偏差2毫米。The chain wheel is installed on the shaft should not be skewed and swing. In the same transmission components in the end of the two sprocket should be located in the same plane, the sprocket center distance of 0.5 meters in the following, allowing the deviation of 1 mm sprocket center distance of 0.5 meters or more, allowing the deviation of 2 mm5.链轮磨损严重后,应同时更换新链轮和新链条,以保证良好的啮合。不能只单独更换新链条或新链轮。否则会造成啮合不好加速新链条或新链轮的磨损。Sprocket wear serious, should be replaced at the same time the new chain and new chain, to ensure good meshing. Can not only replace the new chain or chain wheel. Otherwise it will cause the meshing is not good to speed up the new chain or the new sprocket wear.

    6.新的导轨式升降机链条过长或经使用后伸长,难以调整,可看情况拆去链节,但必须为偶数。链节应从链条背面穿过,锁片插在外面,锁紧片的开口应朝转动的相反方向。Rail lift long chain of new or use after elongation, difficult to adjust, can see to remove the link, but must be an even number. Links should be back through the chain, the lock sheet is inserted in the locking piece outside the opposite direction of rotation of the opening in the.


    本文网址:http://www.jnsjpt.net/jixiexinwen/44.html

  •      最新资讯

关于我们 | 新闻动态 | 产品中心 | 生产案例 | 常见问题 | 荣誉资质 | 联系方式

版权所有: 济南九恒机械制造有限公司     seo技术支持:qq415762134       网站地图

在线咨询